Remote Control - Dyson Hot+Cool AM09 Manuel D'utilisation

Power
Each time the heating mode is selected, it conducts a short
calibration cycle. Airflow will be automatically controlled
during this cycle. Once the calibration cycle is complete, it
will revert to the selected airflow speed.
On first use, the appliance will default to a temperature 3°C
higher than the detected room temperature. Thereafter, the
appliance will remember the last target temperature set.
Select the desired room temperature. Pressing the large
red button increases the target temperature by 1°C; the
smaller red button decreases it by 1°C. The appliance will
not operate in heater mode unless the target temperature
is above the room temperature.

Remote control

Standby
ON/OFF
Airflow speed
control
Sleep timer
Personal
heating mode
Remote control docks magnetically.
Attach the remote control to the top of the
appliance with the buttons facing down.
40 40
Cool mode
Thermostat
control
Oscillation
ON/OFF
Diffused mode
To operate, point the
remote control toward
the front of the base.
Press and hold the power
button to run through the
target temperatures.
Heating and cool modes
Heating mode
Press the red thermostat control button until the digital display
shows the desired target temperature. The power button light will
change from blue to red. The red circle will disappear when the
target temperature has been reached.
Cool mode
Press the blue thermostat control button to change the target
temperature to 0°C. The power button light will change from red
to blue. To adjust the airflow speed use the airflow control button.