Before The First Use; Power Sources - AudioSonic CD-1593 Mode D'emploi

BEFORE THE FIRST USE

• Take the appliance and accessories out the box. Remove the stickers, protective
foil or plastic from the device.
• Place the device on a flat stable surface and ensure a minimum of 10 cm. free
space around the device. This device is not suitable for installation in a cabinet or
for outside use.

POWER SOURCES

AC power
You can power your portable system by plugging the detachable AC power cord into
the AC inlet at the back of the unit and into a wall AC power outlet. Check that the
rated voltage of your appliance matches your local voltage. Make sure that the AC
power cord is fully inserted into the appliance.
Battery power
Insert 6 x "C" size batteries into the battery compartment. Be sure that the batteries
are inserted correctly to avoid damage to the appliance. Always remove the batteries
when appliance will not be used for a long period of time, as this will cause leakage
to the batteries and subsequently damage to your appliance.
Notes:
• Use batteries of the same type. Never use different types of batteries together.
• When using the appliance with batteries, disconnect the AC powercord.
USE
Basic function
• Press the "ST / FUNC" button in the standby mode, to switch on the system. (FM
radio mode as default mode when switch on the system.)
• Press the "ST / FUNC" button to switch the system to CD/MP3/USB/AUX-IN mode.
• Press and hold the "ST / FUNC" button for 3 seconds to switch off the system. (No
matter in which mode.)
4
Instruction Manual
Radio
• Press the "ST / FUNC" button to select the "RADIO" mode.
• Press the "BAND / ALBUM" button to select AM or FM.
• Adjust radio frequency to your desired station by using the "TUNING" control.
For better reception
• FM: This appliance has a FM antenna located at the rear cabinet. Make sure this
antenna is fully extended.
• AM: This appliance is equipped with a built - AM antenna. Rotate the appliance to
get better reception.
CD / MP3 operation
• Press the "ST / FUNC" button to select "CD" mode.
• Open the CD door and place a CD / MP3 disc with the label up in the CD compartment.
• Close the CD door.
• Focus search is performed when:
- For CD disc - Total number of tracks is read and appears on the display.
- For MP3 disc - "MP3" appears on the display."
• It will start automatically from the first track.
• Press the "VOL + / AL1" or "VOL - / AL 2" button to adjust the volume to the desired level.
• Press the "PLAY / PAUSE" button again when you want to stop playback temporarily.
• Press the "STOP" button when finished.
Folder select
Press the "BAND / ALBUM" button to select a folder. (Folder select function can only
operate if the discis stored with at least 2 directories / files.)
Program
• Up to 20 tracks of CD disc, 99 tracks of MP3 disc can be programmed for disc play
in any order. Be sure to press the "STOP" button before use.
• Press the "MODE" button, the display will show "P01".
• Select desired track by using the "SKIP +" or "SKIP -" button. (You may select a
desired album by pressing the "ALBUM" button).
• Press the "MODE" button again to confirm the desired track into the program memory.
• Repeat step 2 and 3 to enter additional tracks into the program memory.