Location Of Controls; Preparation For Use; On/Off Button; Power Connection - AudioSonic CL-1460 Mode D'emploi

LOCATION OF CONTROLS

1. On/off button

2. Clock set/memory button
3. Alarm 1 button
4. iPhone / iPod compartment
5. Alarm 2 button
6. Function button
7. SKIP FORWARD / TUNING UP button
8. Volume DOWN button
9. Volume UP button
10. Snooze / Sleep / Dimmer button
11. SKIP BACK / TUNING DOWN button
12. Memory up / play / pause button
13. Display
14. FM antenna (rear of unit)
15. DC IN Jack
16. Battery compartment (bottom of unit)
17. Rating label (bottom of unit)
18. AUX IN Jack
4
3
2
1
10
8 12
9 11
13
5
6
7
14 15 16 17 18

PREPARATION FOR USE

• This unit designed specifically to work with your docking iPhone / iPod. Please
read this instruction book carefully before operating the unit.
• AC-DC adaptor connection : The clock radio unit can be powered by an external
AC-DC adaptor, required the output DC 5V 2A (included).

Power connection

This unit is equipped with a battery back up system; it requires a "AAA" size battery x 2
(not included). Insert the battery in the battery compartment, making certain that the
positive and negative (+and-) battery terminals are attached to the corresponding
terminals on the plate in the battery compartment. Plug the AC-DC adaptor to a
household outlet AC source, connect the adaptor's DC output plug to the DC IN Jack
of the clock unit.If an AC power failure occurs, the clock automatically switches to the
battery power supply, the clock and timer memory continue running. When the AC
power resumes, the clock switches back to AC again.
Please take note that the batteries are for backup only and not for operational use,
the batteries will provide backup for approx. 48 hours if the provided batteries are full,
when you are unplugging the device for a longer period make sure to remove the
batteries.
OPERATING INSTRUCTIONS
Setting time using iPhone / iPod time Sync
The clock radio time sync feature allows you to sync the time setting on the clock
radio to the time from you iPhone or recent model iPod (iPod touch / iPod nano and
iPod classic; older iPod models such as iPod mini do not support this feature).
1. Plug the AC adaptor cable into the AC adaptor jack located at the back of the
unit, time sync flashes on the lower part of the display.
2. Once sync is completed, time updated will appear on the display.
3. If sync was not successful, If this happens, please try again with a different iPhone
/ iPod if needed.
EN
Instruction Manual
3