Zanussi ZWQ 6100 Notice D'utilisation page 6

"Easy iron" option
If you select this option, the laundry is washed
and spun delicately to prevent any creasing.
This makes ironing easier.
"Extra rinse" option
The washing machine will add one or more rin-
ses during the cycle. This option is recommen-
ded for people with sensitive skin and in soft
water areas.
Temporary : Press the "Extra rinse"
The option is only active for the selected pro-
gramme.
Permanent : Hold down the "Eco"
tra rinse" buttons for a few seconds. The
option is permanently activated, even if the ap-
pliance is switched off. To deactivate it, repeat
the process.
"Delay start"
This option allows you to delay the start of a
wash programme by 30 minutes, 60 minutes,
90 minutes, 2 hours to 20 hours. The selected
time appears on the display for a few seconds.
You can change or cancel the delayed start
time at any time before you press the "Start/
Pause" pushbutton, by pressing the "Delay
start" pushbutton again (
mediate start).
If you have already pressed the "Start/Pause"
pushbutton and you want to change or can-
cel the delayed start, proceed as follows :
• To cancel the delayed start and start the cy-
cle immediately, press "Start/Pause"
then "Delay start"
to start the cycle.
• To change the timer delay period, you must
go through the "Stop"
programme your cycle.
The lid will be locked during the delayed start
time. If you need to open it, you must first pause
the appliance by pressing the "Start/Pause"
pushbutton. After closing the lid again, press
the "Start/Pause"
Start of the programme
Press the "Start/Pause"
the cycle ; the corresponding light will come on
6
button.
and "Ex-
' indicates im-
. Press "Start/Pause"
position and re-
pushbutton.
pushbutton to start
green. The
is normal for the programme selector to remain
stationary during the cycle. The remaining time
appears on the display. If a delayed start has
been selected, the countdown appears on the
display.
Interrupting a programme
Adding washing during the first 10 mi-
nutes
When the
by proceeding as follows. Press the "Start/
Pause" pushbutton : the corresponding light
will flash green while the appliance is paused.
The lid can only be opened around 2 minutes
after the washing machine has come to a stop.
Press the "Start/Pause"
continue the programme.
.
Modifying the programme in progress
Before making any changes to the current pro-
gramme, you need to pause the washing ma-
chine by pressing the "Start/Pause
button. If the modification is not possible, "Err"
flashes in the display and the "Start/Pause"
pushbutton flashes red for a few seconds. If
you still decide to change the programme, you
must cancel the current programme (see be-
low).
.
Cancelling the programme
If you want to cancel the programme, turn the
programme selector to the "Stop"
and
End of the programme
The washing machine stops automatically ; the
"Start/Pause"
flashes on the display. The lid can only be
opened around 2 minutes after the washing
machine has come to a stop. The
locked) is off. Turn the programme selector to
the "Stop" position
plug and close water inlet tap.
Stand by : once the programme has finished
after a few minutes the energy saving system
will be enabled. The brightness of the display is
reduced. By pressing any button the appliance
will come out of the energy saving status.
indicator lights up (lid locked). It
light is off, you can add washing
pushbutton again to
pushbutton goes out and
. Remove washing. Un-
www.zanussi.com
push-
position.
light (lid