Functional Description - Makita PC5000C Manuel D'instruction

5. This is a dry-use tool. Never use water or
coolant. If water or coolant gets into the tool or
offset diamond wheel, damage to the tool or a
dangerous situation may occur.
6. Adequate ventilation of your work area is very
important when using this tool. Use a dust
mask or appropriate respirator.
7. Due to the dusty nature of this tool, be sure to
clean it often to remove dust accumulations.
Carefully blow the dust out of the motor,
switch and dust cover areas frequently.
8. Always install the dust cover before operation.
9. Always use Makita offset diamond wheels only.
Never use ordinary diamond wheels which
may be available on the market. Never use
depressed center wheels, cut-off wheels, or
any other type of accessory on this tool.
Failure to do so may result in serious injury or
death to operator or anyone nearby.
10. Check the offset diamond wheel carefully for
cracks or damage before operation. Replace
cracked or damaged wheel immediately.
11. Before using the tool on an actual workpiece,
let it run for a while, keeping it away from your
body. Watch for vibration or wobbling that
could indicate poor installation, a poorly
balanced wheel, or a damaged wheel.
12. Hold the tool firmly with both hands during
operation.
13. Do not leave the tool running unattended.
Operate the tool only when handheld. Do not
fasten or mount the tool to a bench, table or
vise and then introduce workpieces to the
tool.
14. Do not touch the offset diamond wheel
immediately after
extremely hot and could burn your skin.
15. Do not bear down on tool. Work the tool away
from and toward you without bearing down on
it. Otherwise the planer will leave marks on the
surface, the motor speed will drop and suction
efficiency will decrease.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
operation; it may
Symbols
The followings show the symbols used for tool.
･
･
･
･
･
･
･

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
B
be
008415
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and
returns to the "OFF" position when released.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To prevent the switch trigger from accidentally pulled, a
lock lever is provided. To start the tool, push in the lock
lever (B) and then pull the switch trigger (A). Release the
switch trigger to stop. For continuous operation, push in
the lock lever (B), pull the switch trigger (A) and then
push in the lock lever (B) further. To stop the tool from
the locked position, pull the switch trigger (A) fully, then
release it.
4
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute
1. Lock lever
2. Switch trigger
2
A
1
USD201-2