Charger; Detaching The Lift From The Rail System - human care 55000 Manuel De L'utilisateur

Charger

The indicator on the lift flashes red when the
batteries need recharging. Plug the charger
cable into the hand control or put the hand
control into the charger cradle and charging
will start. When the lift is charging the indicator
glows yellow.
The lift can only be used with a charger
recommended by Human Care, article
number 50880.
• Charge the lift regularly, preferably every
night
• The charger must be disconnected when
you use the lift
• The lift's function is blocked during
charging. Disconnect the charger to use the
lift
• The unit charges regardless of the position
of the main switch
• If the emergency stop is activated the
lift cannot be charged. Check that the
emergency stop is not activated when
charging.
• The charger must only be connected to an
earthed socket.

Detaching the lift from the rail system

Remove the pins holding the two bolts to the
rail roller. Hold the lift firmly and remove both
bolts. The lift is now disconnected from the rail
roller.
Place the lift on a flat surface. Press the Up
button on the lift to move the belt back. Make
sure the belt is kept taut and gets rolled up in
the lift straight, without folding.
28
If rail charging is available via the rail, the lift
will charge continuously when the lift is not in
use and is within the charging zone. When rail
charging is available, the lift does not need to
be charged via the hand control. Get in touch
with the system owner or Human Care if you
are uncertain as to what type of charging to
use.
Important! When the batteries
o
reach a critically low battery level,
it will no longer be possible to
perform more lifts (up or down). However,
there is still enough battery power for
emergency lowering. See separate
manual for the charger, 99599.
Press the Up button on the hand control or
control panel on the lift to lift the patient.
Press the Down button on the hand control or
control panel to lower the patient. Pressing the
button activates a soft start, and releasing it
causes a soft stop.
Important! When the lift is taken
o
down, the belt must be kept taut
while it is fed into the lift.
www.humancaregroup.com
ENG
ENG