Symbols On The Unit And Product Label; Functions - human care 55000 Manuel De L'utilisateur

Symbols on the unit and product label

CE marking
f
Date of manufacture
g
Manufacturer
h
Max. load
j
I nstructions: Read the
instructions and make sure
you understand them
before using this product
Article number/reference
l
number
Serial number
n

Functions

Emergency stop
In an emergency, the emergency stop can be
activated by pulling the red belt. To reset the
emergency stop, push up the activation plate
at the top of the belt.
Emergency lowering
In the event of an emergency, the emergency
lowering button on the lift or hand control
can be pressed to quickly lower the lift. An
audio signal indicates that the lift is lowering.
Always ensure that emergency lowering can be
performed as safely as possible for the patient.
The emergency lowering button only works
when the lift is switched on and emergency
stop has been deactivated.
The emergency lowering button
o
must only be used in emergency
situations.
Safety catch
The lift is equipped with a safety catch. This
www.humancaregroup.com
Warning
o
The lift contains lead bat-
q
teries and electronics and it
must be recycled appropri-
ately.
Third party certification
marking (not applicable for
all regions and versions)
Type-B product
p
Switch the product off/
Switch the product on
prevents involuntary falls. If the lift belt is
pulled out too quickly, the safety catch will
engage, thus preventing the fall.
Overheating
The lift has overheating protection which stops
the motor if it gets too hot. Overheating can
occur if the motor is overloaded or operated
continuously for quite a long time. The lift's
work cycle (work:pause) is 15:85. Maximum
continuous operation is two minutes. If this
is exceeded, there is a risk of the motor
overheating.
Belt tension guard
The lift is equipped with a belt tension guard
that prevents unintentional discharging of
the lift belt. It must be loaded in order to be
able to pull the belt out. Pull gently on the
belt while at the same time pressing the Down
button on the hand control or control panel.
The weight of the bar is sufficient for the belt
to be fed out.
ENG
ENG
25