Bosch Quigo Notice Originale page 27

OBJ_BUCH-2562-002.book Page 27 Monday, December 14, 2015 2:32 PM
Loosen the fastening screw 15 of the holder, mount the holder to the desired
location and tighten the fastening screw again.
Place the measuring tool via the tripod mount 6 onto the 1/4" male thread 13 of
the holder and screw it on applying moderate force. Do not overtighten the
measuring tool, otherwise it can become damaged.
Adjust the holder roughly before switching on the measuring tool. For this,
loosen the locking screw 14 for the holder and move the measuring tool until
horizontally positioned at the desired height. Retighten the locking screw.
You can also mount the measuring tool on the holder using the adapter plate 3.
Working with the Tripod (Accessory)
A tripod offers a stable, height-adjustable measuring support. Place the measur-
ing tool via the tripod mount 6 onto the 1/4" male thread of the tripod and screw
the locking screw of the tripod tight.
Adjust the tripod roughly before switching on the measuring tool.
You can also mount the measuring tool on the tripod using the adapter plate 3.
Working with the Adapter Plate (see figure B–C)
The adapter plate 3 makes it easier to precisely align the measuring tool with a
reference point and enables you to quickly attach and detach the measuring tool.
The adapter plate 3 can be mounted on the holder 16 or tripod 11.
– Holder: Place the adapter plate with the 1/4" mount 1 on the screw 13 of the
holder and tighten it to the holder applying moderate force.
Note: Loosen the locking screw 14 of the holder if you want to change the po-
sition of the measuring tool. If the adapter plate is turned without loosening
the locking screw, the adapter plate can become loose and the measuring tool
can fall off.
– Tripod: Tighten the locking screw of the tripod in the 1/4" mount 1 of the
adapter plate.
Bosch Power Tools
English | 27
1 609 92A 1EC | (14.12.15)