Makita PW5001C Manuel D'instruction page 6

CAUTION:
If the tool is operated continuously at low speeds,
•
the motor will get overloaded and heated up.
The speed adjusting dial can be turned only as far
•
as 5 and back to 1. Do not force it past 5 or 1, or the
speed adjusting function may no longer work.
Electronic function
Constant speed control
Possible to get fine finish, because the rotating speed is
kept constant even under the loaded condition.
Additionally, when the load on the tool exceeds
admissible levels, power to the motor is reduced to
protect the motor from overheating. When the load
returns to admissible levels, the tool will operate as
normal.
Soft start feature
Soft start because of suppressed starting shock.
Opening or closing of water lever
3
B
2
A
1
004732
To keep the lever on the tool for water flow open, turn it to
the position A where the water passage will be ready.
Return it to the position B to close.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Installing side grip (handle)
006099
CAUTION:
Always be sure that the side grip is installed
•
securely before operation.
1. Lever
2. Open
3. Close
6
Screw the side grip securely on the position of the tool as
shown in the figure.
Remove one of the screws which secure gear housing
and head cover, then screw the side grip on the tool.
1
2
005588
Installing or removing the front grip
2
005586
CAUTION:
Make sure that the front grip is installed securely
•
before operation.
The front grip and the side grip cannot be installed
•
at the same time.
Remove two screws and then the head cover.
(The front grip cannot be installed during the installation
of head cover on the tool.)
Install the front grip on the tool so that its stopper fits to
the gear housing and tighten the two screws as shown in
the figure.
(The front grip and the side grip cannot be installed at the
same time.)
1
2
005587
1. Head cover
2. Side grip
3. Screw
3
1. Head cover
1
2. Screw
1. Gear housing
2. Stopper
3
3. Front grip
4. Flat washer
4
5. Hex socket head
bolt
5