Cleaning And Maintenance - Clatronic HSM 3441 NE Mode D'emploi

Cut Hair / Beard
• Select the cutting length.
• Connect the mains plug to a properly installed isolated ground receptacle 230 V~ /
50 Hz.
• Slide the On/Off switch (2) to position "1".
NOTE:
• Start by using the biggest comb attachment and cut your hair/whisker step by step to
the desired length.
• The hair length adjuster (3) allows you to set the exact cutting length and to use the
comb attachments effectively.
Outlining and Shaving the Neck
• The clipper head allows outlining the shape of the beard, even in difficult to reach places
as well as shaving the hairline at the neck.
• Turn the hair clipper off with the switch (2).
• Remove the comb attachment and turn the device on again.
Finish Operation
Slide the On/Off switch (2) after use to the position "0" and disconnect from the mains.
Regular cleaning and maintenance ensures optimum results and long lifetime.
WARNING:
• Turn the device off and disconnect the mains plug.
• Do not submerge the unit in water. This would cause electric shock or fire.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
• Use the cleaning brush to remove remaining hair after use.
• Therefore, take off the comb attachment.
• Regularly apply 1 - 2 drops acid-free oil to the clipper head.
• Clean the casing with a slightly damp cloth, if necessary.

Cleaning and Maintenance

GB
49