Hama 179779 Mode D'emploi page 16

To activate the volume punch-through function:
• Press the desired device key (e.g. TV).
• Press and hold the "VOL+" button.
• Press the desired device key (e.g. SAT).
• Release the "VOL+" key again (the LED flashes once when the setting is
activated).
To deactivate the station punch-through function:
• Press the desired device key (e.g. TV).
• Press and hold the "VOL-" button.
• Press the desired device key (e.g. SAT).
• Release the "VOL-" key again (the LED flashes twice when the setting is
deactivated).
6.3 Macro Power
Macro Power allows you to switch two AV devices on/off simultaneously.
To activate the Macro Power function:
• Press the desired device key (e.g. TV).
• Press and hold the "POWER" button.
• Press the desired device key (e.g. SAT).
• Release the "POWER" button again (the LED flashes once when the setting
is activated).
To deactivate the Macro Power function:
• Press the desired device key (e.g. TV).
• Press and hold the "POWER" button.
• Press the desired device key (e.g. SAT).
• Release the "POWER" button again (the LED flashes twice when the setting
is deactivated)
7.Maintenance
• Never use old and new batteries in the universal remote control at the same
time, as old batteries tend to leak and can lead to a loss of performance.
• Never clean the universal remote control with scouring agents or harsh
cleaning agents.
• Keep the universal remote control free of dust by cleaning it with a dry soft
cloth.
8.Troubleshooting
Q. My universal remote control does not work!
A. Check the AV device. If the main switch on the device is off, the universal
remote control cannot operate the device.
A. Check that the batteries are inserted correctly and that the polarity has
been observed.
A. Check that you have pressed the appropriate device button for the device.
A. Replace the batteries if the battery level is low.
Q. If there are multiple device codes listed for the brand of my AV device, how
do I select the correct device code?
A. To determine the correct device code for the AV device, test the codes one
after the other until most of the buttons work properly.
Q. My AV device only responds to some key commands.
A. Try other codes until most of the buttons work properly.
Q. The brand of my AV device is not mentioned in the code list.
A. In this case, use the manual code search (Section 5.2) or the automatic
code search (Section 5.3). During the code search, all codes for a device
type are tested across manufacturers, e.g. all codes for SAT receivers
regardless of the manufacturer.
Q. I have tried all the available codes for the brand of my AV device from the
code list, but none of the codes mentioned work.
14