Hama 179779 Mode D'emploi page 12

• Protect the product from dirt, moisture and overheating and use it in dry
rooms only.
• Do not use the product in areas in which electronic products are not
permitted.
• Do not drop the product and do not expose it to any major shocks.
• Do not modify the product in any way. Doing so voids the warranty.
• Keep the packaging material out of the reach of children due to the risk of
suffocation.
• Dispose of packaging material immediately in accordance with the locally
applicable regulations.
• Do not operate the product outside the power limits specified in the
technical data.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not attempt to service or repair the product yourself. Leave any and all
service work to qualified experts.
• Only use the article under moderate climatic conditions.
Warning - Batteries
• When inserting batteries, note the correct polarity (+ and - markings)
and insert the batteries accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that match the specified
type.
• Before you insert the batteries, clean the battery contacts and the polarity
contacts.
• Do not allow children to change batteries without supervision.
• Do not mix old and new batteries, or batteries of different types or from
different manufacturers.
• Remove the batteries from products that are not being used for an
extended period (unless these are being kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow them to enter the
environment. They can contain toxic, environmentally harmful heavy
metals.
• Remove spent batteries from the product and dispose of them without
delay.
• Avoid storing, charging and using in extreme temperatures and at
extremely low atmospheric pressures (such as at high altitudes).
4.First steps - Inserting the batteries
Note
• Alkaline batteries are recommended. Use two batteries of the type "AAA"
(LR 03/Micro).
• Remove the battery cover on the back of the universal remote control (A).
• Insert the batteries, observing the "+/-" marks for polarity (B).
• Close the battery compartment (C).
Note: Code memory
• When replacing the batteries, all the codes you have programmed remain
stored for up to 10 minutes. Make sure that you do not press any buttons
until the new batteries are inserted in the remote control. If you press a
button and there are no batteries in the remote control, all codes will be
deleted.
10