Kemper Clean Air Tower Mode D'emploi page 62

- Service terminal (pos. 5)
Connection for KEMPER service. Through this interface the KEMPER service
can perform pressure measurements.
- Differential pressure connection (pos. 6)
Intended only for KEMPER service.
- Horn (pos. 7)
Safe collection of dust and smoke is only possible with sufficient suction
capacity. Along with increased dust accumulation in the filter element, its flow
resistance increases and suction performance decreases. As soon as a
minimal value is reached, the alarm horn sounds at regular intervals.
- External connections (pos. 8)
Optional.
NOTE
When first connecting the filter system to the power mains, a self-test
will be conducted, the alarm horn will sound for a short time and the
signal lamps will blink. This should be carried out at regular intervals
(weekly) by the operator by unplugging and replugging the mains plug.
If the alarm horn or signal lights doe not activate at this time, the filter
systemshould be checked by KEMPER-Service.
Serial No.: 150 2206
Technical modifications without previous notification and errors reserved.
KEMPER CleanAirTower Instruction manual - EN
- 62 - Rev.: 2
Status as of: 09/2015