In the next step, it is necessary to connect the individual components with each
other electrically and pneumatically.
Loosen the fiixng screws of the service cover (pos. 1) and remove it.
●
Please ensure that the attached grounding cable is not damaged.
The following figure illustrates a top view of the ventilator unit (with the identification
"A" here) and a bottom view of the filtration unit (with the identification "B" here).
Serial No.: 150 2206
Technical modifications without previous notification and errors reserved.
KEMPER CleanAirTower Instruction manual - EN
Figure 4, Removal of sheet metal cover
Figure 5, grounding and pneumatic system
- 58 -
Rev.: 2
Status as of:
09/2015