Table des Matières
Publicité
DONNEES TECHNIQUES HPS40:
Maximum sample rate
Input amplifier bandwidth (-3dB)
Input impedance
Maximum input voltage
Input coupling
Vertical resolution
Trigger modes
Trigger level
LCD Graphics
Signal storage
dBm measurement (0dBm= 0.775V in 600ohm)
dBV measurements (0dBV= 1V)
True-rms measurement
Peak to peak AC sensitivity (sinewave ref.)
Timebase range in 32 steps
Input sensitivity range in 12 steps
Probe calibration output
Supply voltage
Batteries (option)
Charge current for rechargeable batteries
Battery current (average)
Operating temperature
Fysical characteristics
40MS/s for repetitive signals (10MS/s for single shot events)
From 5MHz at 5mV/div to 12MHz at 50mV, 1V & 20V /div
1Mohm // 20pF (standard oscilloscope probe)
100Vpeak (AC + DC), 200Vpeak-peak (AC only)
DC, AC and GND (GND for auto zero reference)
8 bit + 1bit linearity
Run, Normal, Once, Roll mode for 1s/div and slower timebase
Adjustable in 8 steps
112 x 192 pixels with LED backlight
256 samples with 2 memories, max. 179 samples visible (256 using X shift)
From -73dB tot +40dB (up to 60dB with X10 probe) +0.5dB accuracy
From -75dB tot +38dB (up to 58dB with X10 probe) +0.5dB accuracy
From 0.1mV to 80V (up to 400Vrms with X10 probe) 2.5% accuracy
0.1mV to 160V (1mV to 1000V with x10 probe) 2% accuracy
50ns to 1hour / division
5mV to 20V/division at X1- 50mV to 200V/div at X10
Approx. 2KHz / 4.5Vpp
9VDC/ min 300mA adapter (unregulated) 12VDC if regulated
Alkaline type AA or Ni Cd / NiMH rechargeable ( 5 pcs required)
90mA
On: 170mA, with backlight: 240mA, standby current: < 600µA
0 to 50°C (32 to 122°F)
Dim: 105x220x35mm (4.13x7.95x1.38") Weight 450g (16oz.) ex.
Batteries
HHPS40/10 - FR - 2002
Publicité
Table des Matières
