Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3. The battery
11
12
13
14
15
54
3.3 Fitting and removing the battery
Fitting the battery
•
Make sure the bike is firmly on its stand.
•
Hold the battery with both hands, position the front of the
battery so that the recesses on the side of the battery are in
line with the battery guides on the luggage carrier (ill. 11).
•
Ensure that the bike key is in the battery lock. Rotate it a
quarter turn clockwise while push-ing the battery with your
free hand in a forward direction until it can't go any further.
Take note: the bike key must always be in the battery lock
or else you can't completely push in the battery (ill. 12).
•
Remove the key from the battery lock and replace it in the
bike lock, unlock the bike (ill. 13+14).
•
Check whether the battery is securely held by pulling gently
on it (ill. 8).
•
If this is not the case, repeat the previous 3 steps. If the
battery is fitted properly, your dis-play will also be activated.
Removing the battery
•
Lock your bike (or use the spare key) and insert the bike key
into the battery lock (ill. 16).
•
Turn the key a quarter turn clockwise, while gently pulling
the hand grip at the bottom of the battery backwards (ill. 17).
•
Pull the battery backwards via the guides. We advise you
to support the battery with two hands when it is nearly
removed (ill. 18+19).
•
The battery is ergonomically shaped and has a hand grip
so that it is easy to take with you (ill. 20).
Publicité
Table des Matières
