Hoover MISTRAL TMI 2015 Mode D'emploi page 5

removing a Blockage
1. check if the dust container is full. If so refer to 'Emptying The Dust container' .
2. If the dust container is empty, but suction is still low:
A. Do the filters need cleaning? If so refer to 'cleaning the washable filters' .
b. check if there is any other blockage in the system - Use a rod or a pole to remove
any blockage from the tubes or hose.
c. check for and clear any blockage in the nozzle.
warning - If the cleaner is used for a significant period of time with a blockage, a thermal
cut out will switch the cleaner off to prevent overheating. If this should happen, switch
the cleaner off, unplug and correct the fault. It will take about 45 minutes for the cut out
to automatically reset.
AccESSORIES AND NOZZlES
All accessories can be fitted to the handle or the end of the telescopic tube.
Crevice tool [1r]– for corners and hard to reach areas. Remove the crevice tool from the
accessories holder [24] and fit to the handle [25] or telescopic tube.
dusting Brush [1S] – for bookshelves, frames, keyboards and other delicate areas. Remove
the dusting brush from the accessories holder [24] and fit to the crevice tool then fit to the
handle [25] or telescopic tube.
parquet nozzle** – for parquet floors and other delicate floors. [1V]
pet hair remover mini turbo nozzle* - Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet hairs
removal. [1W]
allergen remover mini turbo nozzle* – Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for allergen
removal. [1X]
grand turbo nozzle* – Use the Grand Turbo Nozzle for deep cleaning on carpets. [1Y]
important: Do not use the Grand Turbo Nozzle or Mini Turbo Nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.
*Certain models only
MistralManual__1-4_union.indd 3
USER cHEcKlIST
Should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another electrical
appliance.
• Is the dust container over-filled? Please refer to 'cleaner Maintenance' .
• Is the filter blocked? Please refer to 'cleaner Maintenance' .
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage' .
• Has the cleaner overheated? If so, it will take approximately 45 minutes to automatically
reset.
IMPORTANT INfORMATION
hoover Spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local Hoover
dealer or direct from Hoover. when ordering parts always quote your model number.
Consumables:
• Pre-Motor filter:
• Exhaust filter:
Spares:
• carpet & floor Nozzle:
• Hose:
• Parquet Nozzle:
• Mini Turbo Nozzle:
• Turbo Nozzle:
3
gB
S112 35601237
T106 35601238
G72 4845090
D122 35601055
G90Pcb 35600934
J32 35600817
J57 35601239
01/07/2011 17.54.44