Connecting To A Computer Or A Network; Connecting The Camera To A Computer - Sony SNC-Z20N Manuel D'installation

About the power source
Use the 12 V DC or 24 V AC power source
isolated from the 100 to 240 V AC.
The usable voltage range is as follows:
12 V DC: 10.8 to 13.2 V
24 V AC: 21.6 to 26.4 V
Use the UL cable (VW-1 style 1007) for 12
V DC or 24 V AC connection.
For the 24 V AC power source, connect the
ground to the U terminal.
Recommended camera cable for
each power source
12 V DC
Cable #24 #22
(AWG) (0.22 (0.33
mm) mm)
Maximum 10
cable length (33) (50)
(m (feet))
24 V AC
Cable #24 #22
(AWG) (0.22 (0.33
mm) mm)
Maximum 30 50
cable length (98) (164)
(m (feet))
Notes
• When power is supplied to both the power
input terminal and the
power from the
• For details on the connection of the
IEEE802.3af-conforming power supply
system, refer to the Manual supplied with
the power supply system.
#20 #18
(0.52 (0.83
mm) mm)
15 25 40
(82) (131)
#20 #18
(0.52 (0.83
mm) mm)
80 130
(262) (426)
port, the
port is used.
Connecting to a
Computer or a
Network
Connecting the Camera to a
Computer
SNC-Z20N/Z20P (rear)
+
TELE
ZOOM
WIDE
2
10 9 8 7 6 5 4 3 2 1
Network cable (cross,
not supplied)
Computer
1
Using a commercially available
network cable (cross), connect
the (network) port of the
camera to the network
connector of a computer.

Connecting to a Computer or a Network

DC 12V –
AC 24V 1
Network
connector
11
GB