Milwaukee 6580-20 Manuel De L'utilisateur page 5

Installing and Removing Bits
Drywall Ramp-Off Locator Assembly
Fig. 3
Ramp-off
sleeve
Locator
1. Unplug tool. To remove the locator assembly, turn
the ramp-off sleeve while pulling it away from the
tool.
2. Push insert bit into bit holder until it snaps into
place. Push the bit holder into the nose of the
tool until it snaps into place.
3. Push the locator assembly onto the nose of the
tool until it snaps into place.
Installing and Removing Magnetic Sockets on
Adjustable Screwdrivers
For Cat. No. 6580-20
Fig. 4
1. Unplug tool.
2. To remove the magnetic socket, slide the locking
sleeve forward and pull out the socket.
3. To install the magnetic socket, slide the locking
sleeve forward and push in the socket until it is
fully seated.
For Cat. No. 6780-20
1. Unplug tool.
2. To remove the magnetic socket, slide the locking
sleeve forward and pull out the socket.
Fig. 5
3. To install the magnetic socket, simply push in
the socket until it snaps into place.
Bit holder
Insert bit
Socket
Locking sleeve
Socket
Locking sleeve
OPERATION
WARNING
always unplug tool before attaching or remov-
ing accessories or making adjustments. Use
only specifi cally recommended accessories.
Others may be hazardous.
WARNING
wear safety goggles or glasses with side
shields.
Using Forward/Reverse Switch
Fig. 6
Switch
1. For forward (clockwise) rotation, push the for-
ward/reverse switch to the left position as shown.
2. For reverse (counterclockwise) rotation, push
the forward/reverse switch to the right position
as shown.
Although an interlock prevents reversing the tool
while the motor is running, allow it to come to a
full stop before reversing.
WARNING
keep hands and cord away from the bit and
all moving parts.
Starting, Stopping and Controlling Speed
1. To start the tool, pull the trigger.
2. To stop the tool, release the trigger.
3. To vary the drilling speed, simply increase or
decrease pressure on the trigger. The further
the trigger is pulled, the greater the speed.
Locking Trigger
The lock button holds the trigger in the ON position
for continuous full speed use.
1. To lock the trigger, hold the lock button in while
pulling the trigger. Release the trigger.
2. To unlock the trigger, pull the trigger and release.
The lock button will pop out.
Adjusting Locator Assembly
The locator assembly controls the tool's driving
depth. These screwdrivers feature a locator as-
sembly with one-handed depth adjustment. Depth
adjustments can be made easily and quickly by
turning the locator with one hand. Detents inside
the sleeve "lock" the selected depth.
For the drywall ramp-off locator assembly, start
with about 1/16" clearance between the head of
the screw and nose with the snap-action clutch
disengaged as shown.
5
To reduce the risk of injury,
To reduce the risk of injury,
Forward
Trigger
Reverse
To reduce the risk of injury,