Leak Problem; Boiling Noise; Water Is Too Hot - Steam - Atlantic HM Notice D'utilisation Et D'installation

EN
Your water heater: Troubleshooting guide
5.6.

Leak problem

Action to take
Leak located on the hot and cold water take-off s
1. Switch off the electrical power supply
2. Drain the water heater (see page 48).
Leak coming from the nuts located under the plastic cover
1. Switch off the electrical power supply
2. Drain the water heater (see page 48).
Lek gevonden bij de bak
1. Switch off the electrical power supply
2. Drain the water heater (see page 48).
5.5.

Boiling noise

Action to take
1. Check that the noise occurs when the water
heater is in the process
of heating.
On a shielded product, this is a normal occurrence as the resistor is
directly submerged in the water.
5.4.

Water is too hot - steam

Action to take
1.1. Switch the water heater's
power supply off
immediately.
1 1
AUTO AUTO
0 0
1.2. Check the water
heater's electrical wiring.
2.1 Turn off the water heater power
supply.
2.2 Open the plastic cover.
2.3 Lower the temperature setting gradually
using the wheel.
See page 59, Section III Setting
the temperature.
62
Solution
Reconnect all the connections (see page
45, the section on installation).
Replace the closing fl ange seal
Replace the water heater.
Solution
If the noise occurs during heating, descale the
water heater (see
Chapter maintenance page 48).
If the noise does not occur during heating
or it consists of clicking noises, or it occurs
when the valve is turned on, consult a
plumber so that they can fi nd the cause of
the problem.
Solution
Reconnect the water heater's electrical
wiring in accordance with the diagram on
page 58.
Adjust the thermostat to the
desired temperature.
Cause
Poor connector sealing
Damaged seal or leaking heater body.
Tank corrosion.
Cause
Water heater is scaled up.
The water heater is not the cause.
Cause
Connect directly to the resistor ithout passing through
the thermostat.
Thermostat set at the maximum.