Horizontal Wall-Mounted Water Heater- Side Connection; Mounting Procedure; Water Heater Water Connections; Conventional Connection - Atlantic HM Notice D'utilisation Et D'installation

EN
Installation Manual: Fitting the water heater - Water heater water connections
4.4.

Horizontal wall-mounted water heater- Side connection

Essential:
Align the pick-ups vertically with the hot water outlet (red) above the cold water
(blue). (blue).
CEILING

Mounting procedure:

- Assemble the belts and brackets using the nuts and
bolts in the package without tightening them (fi gs. 1 and
2)
- Fit the brackets with their belt on the support (wall, cei-
ling, fl oor), then tighten
- Position the water heater using one of the 4 mounting
options.
- Complete the mounting procedure by tightening the belt
nuts on the bracket
5.

Water heater water connections

The water heater must be connected in accordance with the standards and regula-
tions in the country in which it is installed (for France: DTU Plumbing 60-1).
5.1.

Conventional connection

u Connect the NEW safety unit to the cold water inlet (blue) on your water heater.
v Place the siphon under the safety unit and connect its drain pipe to the drain.
w Tighten the dielectric connection onto the hot water outlet (red) on your water heater.
x Tighten your pipes on your water heater.
Your pipes must be rigid (copper) or fl exible (standardised braided stainless steel hoses)
and able to withstand 100°C and 1 MPa (10 bar). Otherwise, use a temperature limiter.

Dielectric
connection
MANDATORY
Hot water connection
WARNING

applied in
the direction
of screwing
NEW
safety unit

Siphon
MANDATORY
Cold water connection
WALL
Waste water
drainage
FLOOR
fi gure 1 fi gure 2
x 2
45