Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
Removing or installing planer blades
CAUTION:
•
Tighten the blade installation bolts carefully when
attaching the blades to the tool. A loose installation
bolt can be dangerous. Always check to see they
are tightened securely.
•
Handle the blades very carefully. Use gloves or
rags to protect your fingers or hands when remov-
ing or installing the blades.
•
Use only the Makita wrench provided to remove or
install the blades. Failure to do so may result in
overtightening or insufficient tightening of the instal-
lation bolts. This could cause an injury.
To remove the blades on the drum, unscrew the installa-
tion bolts with the socket wrench. The drum cover comes
off together with the blades.
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of the
same dimensions and weight, or drum oscillation/vibra-
tion will result, causing poor planing action and, eventu-
ally, tool breakdown.
2
3
4
5
Place the blade on the gauge base so that the blade
edge is perfectly flush with the inside edge of the gauge
plate. Place the adjust plate on the blade, then simply
press in the heel of the adjust plate flush with the back
side of the gauge base and tighten two screws on the
adjust plate. Now slip the heel of the adjust plate into the
drum groove, then fit the drum cover on it. Tighten the
001605
1. Socket wrench
1
2. Installation bolt
2
001606
1. Bolt
1
2. Drum
3. Planer blade
4. Drum cover
5. Adjust plate
installation bolts evenly and alternately with the socket
wrench.
5
6
1
2
3
4
For the correct planer blade setting
Your planing surface will end up rough and uneven,
unless the blade is set properly and securely. The blade
must be mounted so that the cutting edge is absolutely
level, that is, parallel to the surface of the rear base.
Below are some examples of proper and improper set-
tings.
5
001607
1. Adjust plate
2. Screws
7
3. Heel of adjust
plate
4. Back side of
8
gauge base
5. Blade edge
6. Planer blade
7. Inside edge of
gauge plate
8. Gauge plate
Publicité
Table des Matières
