Akai Professional MPX16 Guide D'utilisation page 10

Editing Pads
To edit a pad's parameters, press the Pad Edit button to cycle through the available
parameter families, and then use Parameter Knobs A–D to adjust their corresponding
parameters.
Parameter Parameter
Family
A: Volume (Vol)
Mix
B: Pan
C: Reverb (Rvb)
A: Tuning (Tun)
Sample
B: Envelope>Tuning (E>T)
C: Sample Start (St.)
D: Sample End (End)
A: Filter Attack (F.A)
Envelopes
B: Filter Decay (F.D)
C: Amplitude Attack (A.A)
D: Amplitude Decay (A.D)
Description
The maximum output level of the pad.
The position of the pad's sample in
the stereo field.
The amount of reverb applied to the
pad. (At 100, the signal is an equal
blend of the wet and dry signals.)
The pitch of the pad.
How much the filter envelope affects
the pad's pitch. (When set to 100, the
envelope will add 12 semitones to the
sample's pitch.)
An offset for the start point of the
sample on the pad. Higher values
move the start point forward in the
sample. This does not affect the
actual sample file or the same sample
assigned to other pads.
An offset for the end point of the
sample on the pad. Higher values
move the end point backward in the
sample. This does not affect the
actual sample file or the same sample
assigned to other pads.
The attack setting
envelope for the pad. This also
depends on the Trigger Mode setting
(see the Utility parameters below).
The decay setting
envelope for the pad. This also
depends on the Trigger Mode setting
(see the Utility parameters below).
The attack setting of the amplitude
envelope for the pad. This also
depends on the Trigger Mode setting
(see the Utility parameters below).
The decay setting of the amplitude
envelope for the pad. This also
depends on the Trigger Mode setting
(see the Utility parameters below).
10
Range/Options
000 – 100
Center (Ctr),
L50 – R50
000 – 100
-12 to +12
semitones
000 – 100
000 – 999
000 – 999
of the filter 000 – 100
of the filter Off,
000 – 999
000 – 100
Off,
000 – 999