Cascade E-SERIE Sideshift Instructions De Montage page 10

P
ERIODIC MAINTENANCE
WARNING: After completing any service
procedure, always test the Clamp through
five complete cycles. First test the Clamp
empty, then test with a load to make sure
the Clamp operates correctly before
returning it to the job.
IMPORTANT: E-Series Clamps are prelubed at the
factory. Lubrication is not necessary for installation.
100-Hour Maintenance
Every time the lift truck is serviced or every 100 hours of
truck operation, whichever comes first, complete the
following maintenance procedures on the Clamp:
• Check for loose or missing bolts, worn or damaged
supply hoses and hydraulic leaks.
• Inspect the cylinder rod retainer blocks and split-ring
keepers for damage. Retainers operate with a loose
clearance and require no lubrication.
• Check for equal movement of the arms.
500-Hour Maintenance
After each 500 hours of truck operation, in addition to the
100-hour maintenance, perform the following procedures:
• Inspect the arm bearing surfaces for wear or damage.
If lubrication is required, silicon spray or light grease is
recommended.
• Check the clearance between the lower mounting hooks
and the truck carriage bar:
Quick-Change Hooks – 3/16 in. (5 mm) max.
Bolt-on Hooks – Tight against lower carriage bar.
If adjustment is necessary, refer to Installation Step 5.
Tighten lower hook capscrews to 165 ft.-lbs. (225 Nm).
1000-Hour Maintenance
After each 1000 hours of truck operation, in addition to the
100 and 500-hour maintenance, perform the following
procedures:
• Tighten frame capscrews (see Table).
• Tighten cylinder rod retainer bar capscrews (see Table).
Model
22E
33E
45E
10
Torque Values
Frame Retainer Bar
100 Nm. 65 Nm.
100 Nm. 65 Nm.
265 Nm. 105 Nm.
Cylinder Rod
Retainers
Bolt-On Lower
Mounting Hook
Back (driver's) view
Cylinder Rod
Retainer Bar
Capscrews (8)
Arm
Bearings
Right Side
CL0293.ill
Frame Quick-Change
Capscrews Lower Mounting
Hook
CL0291.ill