LENCO BT-200 Light Mode D'emploi page 9

G. Use NFC for fast Bluetooth pairing
a. On Bluetooth Speaker:
1. Turn on the unit.
2. Make sure that the NFC detection mark "NFC(8)" is at the right place
to touch.
b. On Mobile Phone:
1. Make sure that the mobile phone has the NFC function turned on and
the screen is active (unlocked).
2. Touch the mobile device's NFC sensor on the Bluetooth Speaker's NFC
detection mark. Keep touching until the mobile device vibrates and/or
sounds. (When the devices connect, some mobile phones may show a
dialog box on the screen to confirm)
3. After the pairing is successful a tone will be heard from the speaker
and the "Bluetooth (7)" LED will show a steady blue light.
4. To disconnect the Bluetooth Speaker from an NFC connected phone,
touch it with the mobile device again.
Hint: If you cannot connect the unit, try the following:
•
Move the mobile phone slowly over the "NFC" mark of the Bluetooth
Speaker.
•
If the mobile phone is in a case (especially metal), remove it from the
case.
H. Bluetooth Music Playing Controls (two way function)
a. On your Bluetooth Device:
1. Switch to the music player menu and choose music to start playing
from the playlist or by using the "</V-,>/V+" button. Play/Pause the
playing music by using the " / " button.
2. To adjust the volume level use the device's volume control
"</V-,>/V+"" button on your Bluetooth device. (refer to your device's
user manual when necessary)
b. On Bluetooth Speaker:
1. While playing music, press the " /
playing music. Press it again to resume.
2. Press and hold the ">/V+ (6)" button to increase the volume level.
3. Press and hold the "</V- (5)" button to decrease the volume level.
4. When the maximum or minimum volume is reached, a beep sound
will be heard. (Not for interconnection mode)
5. Press the ">/V+ (6)" button to change to the next music file.
6. Press the "</V- (5)" button to change to the previous music file.
I. Calling Function
1. When there is an incoming call during the Bluetooth music playing
mode:
2. The ringing sound (an incoming call) will be heard and the playing
music will pause automatically.
(4)" button to pause the
8