LENCO BT-200 Light Mode D'emploi page 8

3. In this case, the Bluetooth Speaker will turn back into the
"Searching/Pairing" mode in a few seconds, and the "Bluetooth (7)"
LED will turn to slowly blinking in blue.
4. Now, you can pair another mobile device or power Off the Bluetooth
Speaker if you want.
5. Notice: Disconnecting Bluetooth for a long time when the unit is not
turned off, it will be reconnected when you come back.
E. Auto reconnect with paired device
1. Every time you turn On the Bluetooth Speaker's power; it will firstly
search for the mobile device that has been paired previously and that
is still in the speaker's record;
2. The Bluetooth Speaker will reconnect this mobile device as priority if
it is in the Bluetooth searching device mode and within the
connection range.
3. If no device has been found in a few seconds, then the Bluetooth
Speaker will automatically turn into the pairing mode.
4. Now you can pair a new mobile device.
F. Interconnection Bluetooth pairing
1. Press and hold the " /
blinking in blue from lighting, until the "DU" sound is heard and the
blue light flashes slowly. Set it to be the main unit (left channel), the
LED to be flashing fast, and when a song is playing the blue light will
show a steady blue light.
2. Press and hold the " /
blinking in blue from lighting, until the "DU" sound is heard and the
blue light flashes slowly. Set it to be the slave unit (right channel),
and the blue light will blink steadily; this steady blinking will remain
the same when a song is played.
3. Search your phone in the Bluetooth status until it shows "BT-200";
choose it and then both speakers will play music at the same time.
4. When you turn on your mobile phone the next time, there is no need
to set interconnection again, they will match automatically.
Notice in interconnection status:
a. The calling function will remain on main the unit.
b. NFC will work on main unit.
c. If you turn off one of these two speakers then both will be turned off
together; if you would like to turn them on again you have to do this
for both separately.
d. When you insert AUX in into the main unit, both units will be
disconnected from Bluetooth; when you insert AUX in into the slave
unit, the main unit is still working in Bluetooth. When disconnecting
the Aux in, you need to reconnect both units again for the
interconnection.
(4) and >/V+(6) at the same time, fast
(4) and </V-(5) in the same time, fast
7