LENCO BT-200 Light Mode D'emploi page 7

B. About the rechargeable Battery
This Bluetooth Speaker has an internal, non–user-replaceable battery. For
the best results, the first time you use this Bluetooth Speaker, let it
charge for about 6 ~7 hours or until the charging LED indicator light goes
from a red light to 'off' which shows you the battery is fully charged.
To maintain the battery life and performance, if the speaker isn't used for
a while, the battery might need to be recharged. Charge the battery at
least once every month.
To charge the rechargeable battery:
1. Connect the Bluetooth Speaker's "Micro USB socket (10)" with the
original USB cable (supplied), to a USB power charger which is able to
provide an output of at least DC 5V 1A.
2. The "Charge (7)" LED will turn On in red, the battery is charging.
3. The "Charge (7)" LED will turn Off when the rechargeable battery is
fully charged.
4. Disconnect the USB cable when it is done.
C. Power ON and Pairing
1. Press and hold the "
Melody" sound,
searching/reconnect function are open;
2. the "Bluetooth (7)" LED is slowly blinking in blue.
3. Then, activate the Bluetooth function on your Bluetooth device (e.g.
mobile phone); the device will enter the Bluetooth searching mode
automatically; if not, tap the related selection to manually enter the
searching mode. (refer to your device's manual when necessary)
4. Your Bluetooth device should show "BT-200" in the list, and then
select it for pairing. Wait for some seconds and you will see a
'connected' message as shown on your mobile device. If the pairing is
successful, a tone will sound "DU" and the "Bluetooth (7)" LED will
show a steady blue light.
5. Now, you can start to play music from your mobile device by its music
player program.
6. Press and hold the "
Melody" sound to turn Off the device when it is not in use.
Note: In case you own two BT-200 speakers: in case you paired speaker
1 before via Bluetooth, and now you want to pair speaker 2 only, please
remove speaker 1 from your Listed Devices in Bluetooth before trying to
pair speaker 2; otherwise speaker 2 cannot be recognized!
D. Disconnect from paired device
1. To disconnect with the paired device and for the best result, turn Off
the Bluetooth Speaker by pressing the "
2. Or, you can choose "Disconnect" from your Bluetooth paired device
list on your mobile device;
(2)" button until you hear the "Welcome
to turn on
(2)" button until you hear the "Shut Down
6
the device, the
(2)" for a longer time.
Bluetooth