Unpacking The Device - Abus TVAC14000A Notice D'utilisation

Only operate the monitor and camera at locations where temperatures remain within the
permitted ambient temperature range.
Camera -10°~ +50°C, monitor 0°~40°C.
8. Wireless transmission
The wireless transmission range depends on a variety of environmental factors. The local
conditions at the installation location may have a negative impact on the range. When there are
no obstructions between the receiver and transmitter, a range of up to 150 m is possible, but this
range will be considerably smaller within buildings.
The following environmental conditions compromise both the range and frame rate:
mobile communication masts, high-tension pylons, electrical wires, ceilings and walls, devices
with an identical or adjacent wireless frequency.
Warnings
Observe all safety and operating instructions before putting the device into operation for the first time.
1. Observe the following information to avoid damage to the power cable and plug:

Do not modify or manipulate the power cable or plug.

Do not pull the cable when disconnecting the device from the power – always take hold of
the plug.

Ensure that the power cable is positioned as far away as possible from any heating
equipment, as this could otherwise melt the plastic coating.
2. Follow these instructions. Non-compliance with these instructions could lead to an electric shock:

Never open the housing or power supply unit.

Do not insert any metallic or flammable objects into the device interior.

Use surge protection to prevent damage caused by overvoltages (e.g. in electrical
storms).
3. Disconnect defective devices from the power immediately and contact your specialist dealer.
If in doubt, have a specialist technician carry out assembly, installation and connection of the
device. Improper or unprofessional work on the power supply system or domestic installation
puts both you and other persons at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always run
separately from each other. They should not be connected at any point or become connected
as a result of a malfunction.
Avoid the following adverse conditions during operation:

Moisture or excess humidity

Temperatures outside the permitted range

Direct sunlight

Dust or flammable gases, vapours or solvents

Strong vibrations

Strong magnetic fields (e.g. next to machines or loudspeakers)

Unpacking the device

Handle the device with extreme care when unpacking it.
If the original packaging has been damaged, you must start by inspecting the device. If the
device shows signs of damage, return it in the original packaging and inform the delivery
service.
34
English