Feed Water Supply - GE GN1S04C Manuel D'utilisation Et D'installation

Feed Water Supply

Check and comply with local plumbing codes as you plan,
then install a cold feed water supply fitting. For new home installation
using standard plumbing fittings, see first two illustrations below. A typical
installation for existing homes using the saddle valve is shown in third
illustration below.
A. PREFERRED INSTALLATION
Turn off the cold water supply.
1
Complying with plumbing codes, install a fitting on the cold water pipe
2
to adapt 3 ⁄ 8 " OD tubing. A typical connection is shown in illustrations at
right (parts not included). Make sure a water supply valve is used.
Typical location
B. OPTIONAL HOME INSTALLATION Where codes permit
*For 1/2" OD or larger metal tubing only.
NOTE: Codes in the state of Massachusetts require installation by a licensed
plumber and do not permit the use of the saddle valve. For installation,
use plumbing code 248-CMR of the Commonwealth of Massachusetts.
Turn off the cold water supply and attach saddle valve as shown in
1
illustration at right.
DANGER: To protect yourself from serious injury or fatal shock, use
a battery-powered hand drill only to make the hole. DO NOT USE AN
ELECTRIC DRILL.
Close the water supply valve by turning the handle clockwise.
2
Open the main water supply valve and several house faucets to purge
3
air from the system. Close faucets when water runs smoothly.
Some threads
should be visible
Rubber gasket
Cold
water
Snug valve into bracket
DO NOT OVERTIGHTEN
Preferred water supply connection
(using compression fitting)
Cold
water
pipe
Optional water supply connection (using saddle valve)*
*For 1/2" OD or larger metal tubing only.
Nut (2)—not
required if holes
Pre-drill
in clamp are
1⁄4" hole
threaded
Clamp Z
Tubing insert
Tubing adapter
Compression nut
Water supply valve
Insert (not included)
Ferrule
3⁄8" tubing to inlet
Seal—make sure the
seal is in place
Clamp X
Valve
Handle
Use to connect the tubing
5