Sony VPL-X2000U Mode D'emploi page 23

To turn off the power
7
Press the SHIFT key then the arrow keys on the Remote Commander
or the control panel to adjust the vertical position of the picture.
"PICTURE SHIFT" appears on the screen during adjustment.
8
Press the PATTERN key again to clear the HATCH pattern.
To Press
the VOLUME +/– keys.
Adjust the volume
Cut off the sound the AUDIO MUTING key (also cuts off the signal output
from the AUDIO OUT jacks.)
To restore the sound, press the AUDIO MUTING key again
or press the VOLUME + key.
Cut off the picture the PIC MUTING key.
To restore the picture, press the PIC MUTING key again.
Note
Do not look into the lens when the projector lamp is on.
1
Press the STANDBY key on the Remote Commander or the control
panel.
The ON indicator flashes in green and the cooling fan keeps running
for about six minutes to reduce the internal heat. The ON indicator
flashes quickly for one minute. During this time, you will not be able
to turn the power back on. After about one minute, you can turn on the
power with the ON key.
When the fan stops running, the STANDBY indicator lights in red.
Note
To extend the lamp life, do not turn off the power for at least 10
minutes after turning on the power.
23
(GB)