Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
009460
2.
Loosen the (2) magazine mounting screws with
the hex wrench.
009443
3.
Pull the handle/magazine away from the nose of
the tool and clear jam.
4.
Realign the handle/magazine to the nose and
tighten mounting screws.
5.
Reload a strip of nails.
WARNING:
Make sure that the magazine mounting screws are
•
tight and the magazine is tight to nose. Attempting
to fire tool with a loose magazine will result in loss
of nail control, damage to the tool or nail discharge
toward operator.
MAINTENANCE
CAUTION:
Always remove the fuel cell, the battery cartridge
•
and nails before attempting to perform inspection or
maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Cleaning the air filter
009458
1. Screws
1
1. Filter cover
1
2. Filter
2
Press slightly up the fuel cover and pivot it open. And
then remove the filter cover and simply lift out the filter.
Tap the filter lightly to remove any dust. Soap and water
restores the filter to an almost new condition
Maintenance after daily work
At the end of daily work, conduct an end-of-workday
routine.
These simple steps are based on maintaining the safety
and performance of Makita Cordless Clipped Head
Framing Nailer
Before leaving the work site:
1.
Remove the battery cartridge and store in
tool-carrying case. Always use the Cordless
Clipped Head Framing Nailer case for transporting
and storing the tool.
2.
Dispose of all empty fuel cells. Remember to
dispose of these cells where they will not be found
by children, crushed, punctured or burned.
When you get home:
(1)
Place the battery cartridge in its charger if it
needs charging as indicated by the red
indication lamp near the handle.
(2)
Wipe your Cordless Clip Head Framing Nailer
with a clean, soft cloth.
(3)
Check the filter and clean if it is dusty.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Nails
•
Safety goggles
•
Fuel cell
•
Cleaning kit
•
Various type of Makita genuine batteries and
•
chargers
9
or
attachments
Only use
accessory or
are
Publicité
Table des Matières
