Cleaning, Maintenance And Ordering Of Spare Parts; Cleaning The Air Filter; Disposal And Recycling - EINHELL MK 2100 E Instructions D'origine

6. Cleaning, maintance and
ordering of spare parts
To avoid an electric shock or risk of
fire, always pull out the mains plug first
before starting any cleaning work .

6.1 Cleaning the air filter

The air conditioner is fitted with 2 filters.
1. Dust filter (close-meshed filter net)
2. Activated carbon filter (binds particles in the
air and prevents the development of bacteria)
Important: Never use the device without air
filters.
1) Dust filter
Remove the filter cover (Fig. 2/Pos. 8-9) by
pulling it to the side and rear.
Then remove the activated carbon filter. Use a
vacuum cleaner or tap the dust filter gently to
remove the dust. If the filter is very dirty, wash
it carefully with warm water. Then allow to dry
thoroughly.
2) Activated carbon filter
The activated carbon filter is located behind the
top dust filter and cannot be washed. Its service
life is dependent on the operating conditions.
The filter should be inspected and replaced if
necessary. The filter cover then has to be fitted
back on the device with the activated charcoal
filter.
6.2 Cleaning the housing
Use only gentle cleaner and a soft cloth to clean
the housing. Never use aggressive media,
petrol, alcohol or thinner. Only fit the filter back
in place when thoroughly dry.
6.3 At the end of the season
•
At the end of the season, let the device run for
approx. 3 hours in the fan function (FAN).
•
Then roll up the power cable and store it in
the storage compartment provided at the
back of the device (fig. 2/pos. 7).
•
Place a suitable container beneath the
condensate drain and remove the plug. The
trough then empties (see Chapter 5.10).
•
Re-insert the plug in the condensate drain.
Important: If the plug is not inserted or is not
inserted correctly, water will escape the next
time the device is used again.
•
Clean the filter and the housing.
•
Re-insert the filter when thoroughly dry.
GB
•
Store the device in an upright position, prefe-
rably packed in the original box, in a dry and
dust-tight location.
6.4 Maintenance
There are no parts inside the equipment which
require additional maintenance.
6.5 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

7. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
- 24 -