Cleaning The Door Seal; Emptying The Water Reservoir - AEG LAVATHERM 59850 Notice D'utilisation

5. Take out fine strainer.
6. Remove fluff from fine strainer. It is
best to use a moist hand for this pur-
pose.
Clean the full filter area
The strainer area does not have to be
cleaned after every drying cycle, but
should be checked regularly and
cleaned of fluff if necessary.
7. To do this, grip the top of the large
mesh filter and pull it forwards until it
comes loose from the 2 brackets.
8. Remove fluff from the full filter area.
It is best to use a vacuum cleaner for
this purpose.
9. Push both journals of the large mesh
filter into the brackets on the loading
door until they snap into place.
10. Re-insert fine strainer.
11. Push against the large mesh filter until
it locks into the interlock.
If the fine strainer is not fitted, the large
mesh filter will not snap into place and the
loading door cannot be closed.

Cleaning the door seal

Clean the door seal with a moist cloth immediately after the drying cycle is completed.

Emptying the water reservoir

Empty the water reservoir after each drying cycle.
If the water reservoir is full, an active programme will break off automatically and the
empty container
water reservoir must first be empty.
symbol on the display will light up. To continue the programme, the
Care and cleaning
95