Fora IR21 Manuel De L'utilisateur page 11

As a Skin/Surface Scan
Thermometer (IR21)
Step 1
Make sure the probe cover is capped.
Step 2
Turn on the thermometer.
Press and release the On / Memory
button. The thermometer displays
the last measurement.
Step 3
Put the probe on the temple.
Press and hold the Scan button.
Make sure the probe is flat on the
temple, not at an angle.
Step 4
Read the result.
Release the button and read the
result. " " is shown together with a
temperature value and beeps.
NOTE
As the skin/surface scan temperature is likely to be affected by
sweat, oil and the surroundings, the reading shall be taken as a
reference only.
If the probe is placed at an angle on the skin/surface scan, the
reading will be affected by surrounding temperature.
You can perform a skin/surface scan from 3 cm away.
Turn off the thermometer by pressing On / Memory button twice.
Or leave for 3 minutes after a temperature measurement, the
thermometer will automatically turn off.
If you need to take another reading, for the flashing "
flashing before taking another measurement.
EN-9
"