Sleep Timer Setting; Configuration - Scansonic I101BT Guide D'utilisation

8. SLEEP TIMER SETTING

You can set the timer to let the radio goes standby after the
selected time elapsed in the range of 15 minutes to 180 minutes�
Press [ ] button on the remote control to set the timer.
You will see the icon appeared on the display if the timer is set�

9. CONFIGURATION

Here you will find the complete settings/options available to configure
your own tuner. On the main menu, navigate to Configuration setting.
Press OK and you will see a list of options available�
Wi-Fi Network
• Add/Remove AP
Add AP - It will scan out a list of routers around�
Remove AP - If you have already added a router and want to
remove it, choose this option� Note - Always bring the Tuner
within 2 meters of the Wi-Fi router for setup�
• AP: [ ]
If you have added more than one routers on the radio and want
to switch to another one, select this option to change�
• Signal
This is to show the strength of the Wi-Fi Signal of the Wi-Fi
router as received by the radio� Usually signal levels lower than
-70dBm is at weaker level and if it affects the reception of your
radio, you may need to optimize the router location or check
any problem of the router itself�
I101 BT
Alarm Sleep Timer
15