ADE BA 1300 Mode D'emploi page 24

Body analysis
The measured weight will be displayed shortly afterwards. The indicator "o" then runs
across the display; the body analysis is being carried out. Remain standing still.
Your measured values will then be shown to you repeatedly on the display:
Symbol
1.
2.
3.
4.
5.
6.
Calling up stored values
After an analysis has been performed, you can display the values of your last
measurements at any time.
1. Press SET and select your memory cell.
The memory cell indicator stops flashing after a few seconds and the indicator "0.0"
appears on the display, as well as the unit of measurement, e.g. "kg".
2. By pressing or
, select the manual display of the last set of measurements.
3. Press SET in order to switch the scale back into analysis mode.
Weighing tips
‚ Weighing for the body analysis can only be carried out barefoot. In doing so, your
feet should only be lightly moistened. Completely dry feet can lead to false results,
as the electrical conductivity will be poor then.
‚ During the measuring process, stand still and do not hold on to anything.
‚ Do not weigh yourself directly after unusual physical exertion.
‚ Do not weigh yourself immediately after standing up. Wait approximately fifteen
minutes. In this time, the water is able to distribute through your body.
‚ Always attempt to weigh yourself at the same time, in order to obtain comparable
values.
24
Meaning
Your body weight in the set unit of measurement
Your body fat proportion in % with simultaneous evaluation
indicator:
= too little body fat
= slender
= normal
= too much body fat
= obese
Your body water in %
Your muscle mass in %
Your bone mass in kg
Your basal metabolism in kcal
once, select the automatic display or, by repeatedly pressing
Body Analyser Scale BA 1300-1304
or