hager TKP100A Guide De Démarrage Rapide page 25

TKP100 Controller reset modes
For detailled description of use & effect of each reset modes please refer to "TKP100 Reset Modes"
page 22.
Network reset
1. Press the RESET
button for more than
5 seconds
Users reset
1. Press the RESET
button for more than
20 seconds
Factory reset
1. Simultaneously
press RESET
and power on
the TKP100
2. When the unit
flashes in blue,
release RESET
button shortly, then
press it again to
confirm.
Flashing
2. The units flashes
in blue, then when it
starts flashing in yel-
low, release RESET
button shortly, then
press it again to
Flashing
confirm.
2. Maintaining
the RESET button
pressed while the
unit starts flashing
slowly (approximately
5 seconds).
Flashing
3. When successful,
a short series of fast
blue flashes of the
signalling RGB confirm
the reset.
(BLUE)
3. When successful,
a short series of fast
yellow flashes of the
signalling RGB confirm
the reset.
(YELLOW)
3. When the unit flashes
faster in red, release
the RESET button.
Wait for a few minutes
until the unit completely
(RED)
stops flashing in blue,
which indicates the end
of the sequence.
23