Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Step 2.B : Associating an Alarm System
You can easily associate a sepio Hager Alarm System to the TKP100
as follows :
1
"beep"
instal-
lation
mode
The control panel must
be in installation mode.
If it is not, enter :
# 2 # #
master code
(factory: 0000)
Then
# 3 # #
installer code
(factory: 1111)
Note : Only one control panel can be paired to the TKP100.
You will fi nd more detailled information on alarm installation and settings on : www.hager.com/coviva/alarm
2
Press the blue "+"
Button in the coviva
App main page to add a
new Device, and select
"Alarm System".
3
After a few seconds, your
Alarm Control Panel serial
number (last 6 digits) shall
appear in the list. Confi rm
the right Control Panel
serial by clicking "OK".
4
Your Alarm System is
now paired and ready for
use with coviva !
You will always be asked
to type the Alarm installer
code to access the Alarm
System visualisation and
functions from the App.
17
Publicité
Table des Matières
