Connection To A Tv (For Video) - Denon DVM-1805 Mode D'emploi

Masquer les pouces Voir aussi pour DVM-1805:

Mode d'emploi (96 pages)

Table des Matières

Les langues disponibles

Basic Audio

DVD

Audio out

• Method 1 DVD Player + TV with Video Input Jack

• Method 2 DVD Player + TV with S-Video Input Jack

• Method 3 DVD Player + TV with Component Video Jacks

Notes

If your TV is compatible with progressive scanning (480p), connect the TV to the Component Video Output

jacks of the DVD player. Refer to page 12.

Connect the DVD player directly to a TV. If the A/V cables are connected to a VCR, pictures may be

distorted due to the copy protection system.

HOW TO CONNECT TO A TV WITHOUT AUDIO/VIDEO INPUT JACKS

If your TV does not have RCA type audio and video input jacks it is still possible to connect this DVD

player to your TV's 75-ohm coaxial antenna terminal using an optional Stereo Audio/Video RF Modulator, not

included. Connect the audio and video outputs of the DVD player to the audio and video inputs on the RF

Modulator, and then connect the coaxial output of the RF Modulator (usually marked "TO TV") to the 75 ohm

coaxial antenna terminal on your TV. Follow the instruction supplied with the RF Modulator for more details.

If your TV's 75 ohm coaxial antenna terminal is already occupied by an antenna or cable box connection,

remove that cable from your TV's antenna terminal and reconnect it to the coaxial antenna input terminal

of the RF Modulator (usually marked "ANT IN"), then connect the RF modulator to your TV's antenna

terminal as described above.

Note

The picture quality from DVD discs will not be as good if the DVD player is connected to the TV's

antenna terminal through an RF Modulator.