Publicité
(5) Connecting to a Digital Recorder (MD Recorder, DAT Deck, etc.)
Set the "AUDIO SETUP" default setting as shown below. (See page 14.)
• "DIGITAL OUT" → "PCM"
"96k LPCM OUT" → "96k → 48k"
Playing DVDs with incorrect settings may result noise that could damage your ears or the speakers.
DVD-770SD
Optical fiber cable
(6) Connecting to a Stereo Component
DVD-770SD
NOTES:
• When connecting to a stereo device with 2 audio channels
q After setting "SETUP MENU MODE" at "SYSTEM SETUP" to "EXPERT", set "DOWNMIX" under
"AUDIO SETUP" to either "STEREO" or "LT/RT" (see page 15).
For sources recorded in multiple channels, analog signals downmixed into two channels are output. (For
sources for which downmixing is prohibited, only the FL and FR channels are output.)
w Set "96kLPCM OUT" at "AUDIO SETUP" under "SETUP" to "96k>48k" (see pages 15). (When set to
"96k>48k", analog audio signals converted to 48 kHz or less are output for linear PCM sources.)
B
8
9
Digital audio input
connector (OPTICAL)
Stereo component
ENGLISH
9
Publicité
Chapitres
