Battery Replacement - CareFusion Smoke Check Manuel D'utilisation

Bat
and the alarm will sound momentarily after the unit is first switched
on. When the battery has completely expired the above will be
displayed continuously and the battery must be replaced.

Battery Replacement

Locate the sliding cover situated on the rear of the unit, towards the
bottom of the device.
Place your thumb over the round thumb indent, press gently and slide
the cover to the right to remove it from the unit.
Lift the old battery out, and holding the battery terminal by the plastic
body, pull it off the old battery.
Plug the new battery into the battery terminal, taking care that the
correct polarity is observed.
Push the battery back into the battery holder, and replace the battery
cover onto the guides. Slide the battery cover to the left until it is fully
home.
Note: Please remove the battery if the meter is likely to be unused for
some time.
Caution: Do not open the battery cover when the device is turned on.
Caution: The operator should not touch the contacts of the battery
and the patient at the same time.
Please Note: Dispose of the waste battery in accordance with EU
Waste Battery Regulations.
53