Installing The Versarails Mounting Rails - Dell PowerEdge SC1425 Guide D'installation

Installing the VersaRails Mounting Rails

1
At the front of the rack cabinet, position one of the VersaRails mounting rails so that its
mounting-bracket flange fits between the marks (or numbered location) on the vertical rails
(see Figure 1-6).
The three holes on the front of the mounting-bracket flange should align with the holes
between the marks you made on the front vertical rail.
2
Install two 10-32 x 0.5-inch flange-head Phillips screws in the mounting-bracket flange's top-
and bottom-holes to secure the mounting rail to the front vertical rail.
3
At the back of the cabinet, pull back on the mounting-bracket flange until the mounting
holes align with their respective holes on the back vertical rail.
4
Install two 10-32 x 0.5-inch flange-head Phillips screws in the back mounting-bracket flange's
top- and bottom-holes to secure the mounting rail to the back vertical rail.
5
Repeat step 1 through step 4 for the mounting rail on the other side of the rack.
6
Ensure that the mounting rails are mounted at the same position on the vertical rails on each
side of the rack.
Figure 1-6. Installing the VersaRails Mounting Rails
10-32 x 0.5-inch
flange-head Phillips
screws (4 per
mounting rail)
front of rack
1-12
Rack Installation Guide
mounting-bracket flange
mounting rails (2)