Preparation For Use; Mattress Installation; Atmosair Stretcher Mrs - arjo AtmosAir Stretcher Mode D'emploi

Preparation for Use

EN
For information concerning the gurney frame refer to the
manufacturers' User Guide.
1.
Do not use sharp instruments to open boxes. Damage to mattress
could result.
2. Remove AtmosAir Stretcher MRS from plastic protective cover.
The mattress cover may appear wrinkled when unpacked. To remove
wrinkles, allow mattress up to 24 hours to accommodate; see
Troubleshooting
or function, so mattress may be used immediately if needed. Apply
weight to mattress to open valves.
3. Check stretcher mattress surface for tears or cracking; do not use if tears or
cracks are present.
4.
stretcher mattress surface for staining and soiling; clean and / or disinfect as
5.
6. Remove existing mattress from gurney frame.
7. Remove any hook-and-loop material from base frame of patient gurney and / or

Mattress Installation

AtmosAir Stretcher MRS

1. Remove clear backing from hook-and-loop strips located on the underside of the
AtmosAir Stretcher MRS.
2.
of gurney.
side of the hook-and-loop strips adheres to the gurney base, the strips
cannot be pulled up and repositioned.
3.
gurney base.
that may be appropriate. Frame and side rails must be properly sized
relative to the mattress to help minimize any gaps that might entrap a
patient's head or body.
6
Care and Cleaning
Use caution when positioning stretcher mattress. Once the sticky
Always use a standard gurney frame with safeguards or protocols