Rami COMPACT II Manuel Utilisateur page 54

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FRONT PANEL: ANTENNA / AUX RETURN / HYBRID
ANTENNA SECTION :
(1)
Illuminated push button with maintained action to switch internal program On Air.
This switch allows you to select between internal program (Mix output of Compact II) and external mix
(modulation on connectors (A) and (B).
Commutation is made by relays, which keep signal quality at its best, avoiding calibration, while allowing the
commutation of very high amplitude signal. In case of power failure the external program is
automatically switched
(2)
Switch to choice mono or stereo mode with luminous indicator for mono mode. This switch is available on
internal program only.
(3)
Trimmer potentiometer to adjust level internal program (left and right). Range of 14 dB.
(4)
Internal program CUE switch. You can send the modulation of internal program on monitor bargraph and
headphone, independently of position of potentiometers (3).
(5)
External program cue switch. You can see the modulation of external program on monitor bargraph and
headphone.
When (4) and (5) are in on position you can listen external modulation on left and internal modulation on right.
AUX RETURN SECTION :
(6)
Switch to send AUX return (connector F) to Antenna.
(7)
Switch to send AUX return (connector F) to Program 2 / REC.
(8)
Potentiometer to adjust AUX return. (connector F)
(9)
AUX return CUE switch. You can send the modulation of AUX return on monitor bargraph and headphone,
independently of position of potentiometers (8).
HYBRID SECTION :
(10)
Switch to send return to PGM2 when switch (11) is in Antenna.
(11)
Switch to send hybrid in / out to Antenna or Program 2.
(12)
Hybrid return CUE switch. You can send the modulation of hybrid return on (connector G) monitor bargraph
and headphone, independently of position of potentiometers (13).
Adjust the return potentiometer to your hybrid to have on bargraph a level near 0dB with peak modulation of
caller signal.
(13)
Fader 100 mm with VCA interface (Voltage Control Amplifier).
The VCA gain is equal to unity in 0 dB position and +6dB in max position.
RAmi
to Antenna.
17
COMPACT II

Publicité

Chapitres

Table des Matières
loading

Table des Matières