Rami COMPACT II Manuel Utilisateur page 46

REAR PANEL: MICRO / LINE CHANNEL (1 to 5)
(A)
Mic input connector (female 3-pt XLR)
The input is electronically balanced
(Ground in 1, Hot point in 2, Cold point in 3 )
The choice of discrete and high quality components give an excellent signal noise ratio and a low
distortion.
The nominal level is between -70 dBu and -14 dBu
(B)
Insertion jack to line level for (A) input
(C)
Left Line Input on XLR female connector
The input is electronically balanced
(Ground in 1, Hot point in 2, Cold point in 3)
The nominal level is between -14dBu and +12dBu
(D)
Right Line Input on XLR female connector
The input is electronically balanced
(Ground in 1, Hot point in 2, Cold point in 3).
The nominal level is between -14dBu and +12dBu.
(E)
Female DB15 for remote control in / out.
Start / stop remote out is made with opto isolators.
Start / stop remote out is enable only in line position .
All input / output points are fitted with T filters, to protect audio circuits against electrostatic discharges and high
frequency interferences.
Attention : For a good electromagnetic compatibility the point 1 of the XLR is directly connected to steel frame.
RAmi
9
COMPACT II