Rami COMPACT II Manuel Utilisateur page 44

FRONT PANEL: MICRO / LINE CHANNEL (1 to 5)
(1)
Pre gain mic trimmer
How adjust :
(2)
Line mode indicator
(3)
Select switch of balanced mic input or stereo balanced line.
(4)
Mic mode indicator
(5)
Sensitivity potentiometer (range of 25dB). Available in mic and line mode
How to adjust
(6)
Treble potentiometer. Efficacity : +/- 15dB.
(7)
Middle potentiometer. Efficacity : +/- 15 dB.
(8)
Bass potentiometer. Efficacity : +/- 15 dB. For (6), (7) and (8) middle position is flat.
(9)
Aux. out potentiometer. Stereo out
(10)
Choice of pre or post send for Aux.
(11)
To Antenna out switch.
(12)
On indicator of switch (11).
(13)
To PGM2 out switch.
(14)
On indicator of switch (13).
(15)
Left / Right Balance. Middle position is neutral.
(16)
On indicator of switch (15).
(17)
CUE switch. You can send the input modulation to cue bargraph, monitor bargraph and headphones,
independently of the potentiometer position (19).
The Compact II is fitted with analog switch for Antenna, PGM2 and CUE output mix.
(18)
Lighting indicator of electronic detector of potentiometer beginning (19).
(19)
Fader 100 mm with VCA interface (Voltage Control Amplifier ).
The audio signal doesn't cross the potentiometer but it's a 0 to 5 volts signal which command the VCA. The
result is a very long life and absence of unwanted scratch.
A plastic potentiometer option is available.
An electronic detector at the potentiometer beginning (19) (low levels) allows 'Start / Stop' remote control, and
demuting the VCA.
In Line position the remote control start / stop on DB15 (E) is enable.
In Mic position the remote control start / stop on DB15 (E) is disable and start information is send through the
bus bar to switch the external red light interface in the 'Studio' or in the 'Monitor'.
The VCA gain is equal to unity in 0 dB position and +6dB in max position.
RAmi
(Range of 30 dB)
Switch on (17) (CUE) to see on 'cue bargraph' or 'cue monitor' the mic level
Select mic mode with (3) and adjust (5) in middle position
Adjust potentiometer (1) to have a level on bargraph near 0 dB with peak modulation of
microphone.
Switch on (17) (CUE) to see on 'cue bargraph' or 'cue monitor' the level
Adjust potentiometer (5) to have on bargraph a level near 0dB with peak modulation
of input signal
-Pre: Before volume potentiometer (19)
-Post: After volume potentiometer (19)
7
COMPACT II