Rami COMPACT II Manuel Utilisateur page 50

FRONT PANEL: LINE 1 / LINE 2 CHANNEL (6 to 10)
(1)
Line 1 mode indicator.
(2)
Selector for Line 1 (balanced ) or line 2 (unbalanced).
(3)
Line 2 mode indicator.
(4)
Sensitivity potentiometer ( range of 25dB ).
How to adjust : Switch on (13) ( CUE ) to see on 'cue bargraph' or 'cue monitor' the level
(5)
Aux. out potentiometer. Stereo out.
(6)
The choice of pre or post send for Aux. -Pre:
(7)
To Antenna out switch.
(8)
On indicator of switch (7).
(9)
To Pgm2 out switch.
(10)
On indicator of switch (9).
(11)
Balance Left / Right . Middle position is neutral.
(12)
On indicator of switch (13).
(13)
CUE switch. You can send the modulation of input to monitor bargraph and headphone,
independently of position of potentiometer (15).
The COMPACT II is fitted with analog switch for Antenna, Pgm2 and cue output mix.
(14)
Lighting indicator of electronic detector of potentiometer (15) beginning.
(15)
Fader 100 mm with VCA interface (Voltage Control Amplifier).
The audio signal doesn't cross the potentiometer but it's a 0 to 5 volts signal which command the VCA. The
result is a very long life and absence of unwanted scratch.
A plastic potentiometer option is available.
An electronic detector at the potentiometer beginning (15) (low levels) allows remote control start/ stop, and
demuting of VCA.
In Line 1 position the remote control start / stop on DB15 (E) is enable.
In Line 2 position the remote control start / stop on DB15 (E) is disable.
The VCA gain is equal to unity in 0 dB position and +6dB in max position.
RAmi
Adjust potentiometer (4) to have on bargraph a level near 0 dB with peak modulation of input
signal.
-Post: After volume potentiometer (15).
Before volume potentiometer (15).
13
COMPACT II