dirna Bergstrom Bycool DINAMIC 1.1 Instructions De Montage page 32

DINAMIC 1.1
EN
Secure the condenser unit with 6/100x30
5
screws, Ø6 grower washer and Ø6 wide rimmed
flat washer in boreholes where the base of the
unit is supported directly on the riveted nut, and
with 6/100x40 screws, Ø6 grower washer, Ø6
wide rimmed flat washer and 10 mm spacer
inserted between the base of the unit and the
riveted nut in boreholes where the base is not
supported directly on the rivet nut.
5
Mount the pipe couplings in the evaporator
6
couplings. Tighten by turning against the nut
and protect with drip-proof tape.
6
5
32
M6 Rivet nut
Ø6 Grower washer
Ø6 Flat wide-rimmed washer
Support piece
Rear cabin section
6/100x40/60/70
10 mm spacer. (*)
Rear cabin section (*)
5
6
®
5
(*)