dirna Bergstrom Bycool DINAMIC 1.1 Instructions De Montage page 27

DINAMIC 1.1
Screw (1) M6 nut on each stud on the inside
9
of the cabin and position a flat washer. Leave
the upper nuts and washers at upholstery level,
and the lower ones at around 25 mm.
Pass the run-off pipe to the outside through the
10
Ø19 borehole made in the upholstery.
Run the evaporator cabling to the outside
11
through the Ø35 borehole of the upholstery
and take out through the Ø48 borehole in the
plating.
Ø6 Flat washer
M6 Self-locking
nut
Rubber washer
Truck
plating
27
Ø6 Flat washer
M6 Nut
Ø6 Grower
washer
25 approx.
Upholstery
EN
®
M6x110
Stud
M6x140
Stud
10
11