dirna Bergstrom Bycool DINAMIC 1.1 Instructions De Montage page 28

DINAMIC 1.1
EN
Pass the evaporator pipes to the outside
12
through the Ø48 borehole.
Position the evaporator on the M6 studs and
13
secure with M6 nuts, Ø6 grower washers and
flat washers.
VERY IMPORTANT
!
In the case of slanting upholstery, the
evaporator unit must be vertical or sloping
from the lower section to the outside in order to
prevent the condensation water from dripping
onto the upholstery. Before securing the unit,
add water to the run-off tray to check that it
drains correctly.
Upholstery
Evaporator
support piece
Wastewater
tray
28
13
13
®
12